S4048-ON Installation Guide January 2019

PDF

Power

To connect the chassis to the applicable power source, use the appropriate power cord with the S4048–ON. An AC power cord is included with the switch.

When installing AC switches, follow the requirements of the National Electrical Code, ANSI/NFPA 70 where applicable.

The switch is powered-up when the power cord is connected between the switch and the power source.

  • CAUTION: Always disconnect the power cable before you service the power supply slots.
  • CAUTION: Use the power supply cord as the main disconnect device on the AC switch. Ensure that the socket-outlet is located/installed near the equipment and is easily accessible.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\