S4048-ON Installation Guide January 2019

PDF

SFP+ and QSFP+ optic installation

The S4048–ON has six quad small form-factor pluggable plus (QSFP+) optical ports.

For a list of supported optics, refer to the S4048–ON data sheet at www.dell.com/support or contact your Dell EMC sales representative.
  • CAUTION: ESD damage can occur if the components are mishandled. Always wear an ESD-preventive wrist or heel ground strap when handling the S4048–ON and its components.
  • WARNING: When working with optical fibers, follow all the warning labels and always wear eye protection. Never look directly into the end of a terminated or unterminated fiber or connector as it may cause eye damage.
  1. Position the optic so it is in the correct position. The optic has a key that prevents it from being inserted incorrectly.
  2. Insert the optic into the port until it gently snaps into place.
    • NOTE: Both rows of QSFP+ ports require that you install the 40GbE optics with the tabs facing up.
    • NOTE: When you cable the ports, be sure not to interfere with the airflow from the small vent holes above and below the ports.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\