Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

mtu

设置以太网 L2 或 L3 接口的链路最大传输单位 (MTU) 帧大小。

语法
mtu value
参数
value — 输入最大帧大小(以字节为单位),从 1280 到 65535。S3000-ON 的最大帧大小是 12000,而 S4000-ON 是 9216。
默认
1532 字节
命令模式
INTERFACE
使用情况信息

要返回默认 MTU 值,请使用 no mtu 命令。如果 IP 数据包包含 L2 标头,则 IP MTU 必须至少是小于 L2 MTU 的 32 字节。

  • Port-channels
    • 所有成员都必须具有相同的链路 MTU 值和相同的 IP MTU 值。
    • 端口通道链路 MTU 和 IP MTU 必须小于或等于在通道成员上配置的链路 MTU 和 IP MTU 值。例如,如果成员具有 2100 MTU 的链路和 IP MTU 2000,则端口通道的 MTU 值不能高于 2100(对于 IP MTU)或 2000 字节(对于 IP MTU)。
  • VLAN
    注: 首先必须在 VLAN 成员上配置 MTU,然后再配置 VLAN MTU。
    • VLAN 的所有成员必须具有相同的 MTU 值。
    • 标记的成员必须具有一个比未标记成员高 4 个字节的链路 MTU,以对数据包标签进行帐户。
    • 确保 VLAN 成员的 MTU 大于或等于 VLAN MTU。如果您在配置 VLAN MTU 后在 VLAN 成员上配置 MTU,则 VLAN MTU 可能不会更新。OS10 选择 VLAN 或 VLAN 成员上的最低 MTU 值配置为 VLAN MTU。

    例如,VLAN 包含链路 MTU 为 1522 和 IP MTU 为 1500 的标记成员,以及链路 MTU 为 1518 和 IP MTU 为 1500 的未标记成员。VLAN 的链路 MTU 不能超过 1518 字节,并且其 IP MTU 不能超过 1500 字节。

示例
OS10(conf-if-eth1/1/7)# mtu 3000
支持的版本
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\