Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

PDF

port-group

Configures a group of front-panel unified ports, or a double-density QSFP28 (QSFP28-DD) or single-density QSFP28 port group.

Syntax
port-group node/slot/port-group
Parameters
  • node/slot — Enter 1/1 for node/slot when you configure a port group.
  • port-group — Enter the port-group number, from 1 to 16. The available port-group range depends on the switch.
Default
Not configured
Command mode
CONFIGURATION
Usage information
Enter PORT-GROUP mode to:
  • Configure unified ports in Fibre Channel or Ethernet mode and break out interfaces with a specified speed.
  • Break out an MX9116n QSFP28-DD or QSFP28 port group into multiple interfaces with a specified speed.
  • Break out a Z9264F-ON QSFP28 port group into multiple interfaces with a specified speed.
To view the ports that belong to a port group, use the show port-group command.
Example
OS10(config)# port-group 1/1/8
OS10(conf-pg-1/1/8)#
Supported releases
10.3.1E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\