Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell EMC SmartFabric OS10 User Guide Release 10.5.0

Sample configuration

Consider a scenario where traffic from source IP address 1.1.1.1 ingresses through VLAN40 that is part of VRF RED. The egress interface for this traffic is also on the same VRF RED with IP address 4.4.4.4, as shown.

PBR VRF Example

Using the following PBR configuration, you can re-direct traffic ingresssing to VRF RED to a destination that is reachable through the next-hop IP address 2.2.2.2 in VRF BLUE:

  1. Create a route-map.
       OS10(config)# route-map test 
  2. Enter the IP address to match the specified access list.
     OS10(config-route-map)# match ip 4.4.4.4 acl1
    
  3. Set the next-hop address to 2.2.2.2, which is reachable through VRF BLUE.
       OS10(config-route-map)#
         OS10(config-route-map)# set ip vrf BLUE next-hop 2.2.2.2
       OS10(config-route-map)# exit
  4. Apply this rule to the interface where the traffic ingresses, in this case VLAN40.
       OS10(config)# interface vlan 40
       OS10(conf-if-vl-40)#
       OS10(conf-if-vl-40)# ip policy route-map test
  5. (Optional) View the PBR configuration on the interface.
       OS10(conf-if-vl-40)# show configuration
        !
         interface vlan40
         no shutdown
         ip policy route-map test
        !

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\