Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC SmartFabric OS10 User Guide Release 10.5.1

PDF

Configure encapsulated remote port monitoring

Encapsulated remote port monitoring requires valid source and destination IP addresses. Ensure that the source IP address is local and destination IP address is remote. You can also configure the time-to-live (TTL) and differentiated services code point (DSCP) values.

  1. Create monitoring session in CONFIGURATION mode.
    monitor session session-id type erpm-source
  2. Configure source port in MONITOR-SESSION mode.
    source interface interface-type {both | rx | tx}
  3. Configure source and destination IP addresses, and protocol type in MONITOR-SESSION mode.
    source-ip source ip-address destination-ip destination ip-address [gre-protocol protocol-value]
  4. Configure TTL and DSCP values in MONITOR-SESSION mode.
    ip {ttl ttl-number | dscp dscp-number}
  5. Enable the monitoring interface in MONITOR-SESSION mode.
    no shut
Create monitoring session
OS10(config)# monitor session 10 type erpm-source
OS10(conf-mon-erpm-source-10)#
Configure source port, source and destination IP addresses, and protocol type
OS10(conf-mon-erpm-source-10)# source interface ethernet 1/1/2
OS10(conf-mon-erpm-source-10)# source-ip 1.1.1.1 destination-ip 3.3.3.3 gre-protocol 35006
OS10(conf-mon-erpm-source-10)# ip ttl 16
OS10(conf-mon-erpm-source-10)# ip dscp 63
OS10(conf-mon-erpm-source-10)# no shut
View configured ERPM session 
OS10(conf-mon-erpm-source-6)# do show monitor session all

S.Id  Source     Destination  Dir   Mode  Source IP  Dest IP  DSCP  TTL  Gre-Protocol State Reason
--------------------------------------------------------------------------------------------------
6   ethernet1/1/2 remote-ip   both  port  1.1.1.1    3.3.3.3   63    16  35006         true  Is UP
View running configuration of monitor session
OS10# show running-configuration monitor
!
monitor session 10 type erpm-source
source-ip 1.1.1.1 destination-ip 3.3.3.3
source interface ethernet1/1/2
no shut

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\