Dell EMC SmartFabric OS10 User Guide Release 10.5.1

NTP is disabled by default. To enable NTP, configure an NTP server where the system synchronizes. To configure multiple servers, enter the command multiple times. Multiple servers may impact CPU resources.

• Enter the IP address of the NTP server where the system synchronizes in CONFIGURATION mode.

  ntp server ip-address

View system clock state

OS10(config)# do show ntp status
system peer:          0.0.0.0
system peer mode:     unspec
leap indicator:       11
stratum:              16
precision:            -22
root distance:        0.00000 s
root dispersion:      1.28647 s
reference ID:         [73.78.73.84]
reference time:       00000000.00000000  Mon, Jan  1 1900  0:00:00.000
system flags:         monitor ntp kernel stats
jitter:               0.000000 s
stability:            0.000 ppm
broadcastdelay:       0.000000 s
authdelay:            0.000000 s

View calculated NTP synchronization variables

OS10(config)# do show ntp associations
     remote           local    st poll reach  delay   offset    disp
=======================================================================
 10.16.150.185   10.16.151.123 16 1024    0 0.00000  0.000000 3.99217
OS10# show ntp associations
     remote           local    st poll reach  delay   offset    disp
=======================================================================
 10.16.150.185   10.16.151.123 16 1024    0 0.00000  0.000000 3.99217