Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell EMC SmartFabric OS10 User Guide Release 10.5.1

PDF

route-map

Enables a route-map statement and configures its action and sequence number.

Syntax
route-map map-name [permit | deny | sequence-number]
Parameters
  • map-name — Enter the name of the route-map. A maximum of 140 characters.
  • sequence-number — (Optional) Enter the number to identify the route-map for editing and sequencing number from 1 to 65535. The default is 10.
  • permit — (Optional) Set the route-map default as permit.
  • deny — (Optional) Set the route default as deny.
Default
Not configured
Command Mode
CONFIGURATION
Usage Information
NOTE: Exercise caution when you delete route-maps — if you do not enter a sequence number, all route-maps with the same map-name are deleted.
The no version of this command removes a route-map.
Example
OS10(config)# route-map route1 permit 100
OS10(config-route-map)#
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\