VXLAN and BGP EVPN Configuration Guide for Dell EMC SmartFabric OS10 Release 10.5.2

PDF

clear mac address-table dynamic nve remote-vtep

Clears all MAC addresses learned from a remote VTEP.

Syntax
clear mac address-table dynamic nve remote-vtep ip-address
Parameters
remote-vtep ip-address
Clear MAC addresses learned from the specified remote VTEP.
Default
Not configured
Command mode
EXEC
Usage information
To display the MAC addresses learned from a remote VTEP, use the show mac address-table nve remote-vtep command. Use this command to delete all MAC address entries learned from a remote VTEP.
Example
OS10# clear mac address-table dynamic nve remote-vtep 32.1.1.1 
Supported releases
10.4.2.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\