VXLAN and BGP EVPN Configuration Guide for Dell EMC SmartFabric OS10 Release 10.5.2

PDF

member-interface

Assigns untagged or tagged VLAN traffic on a member interface to a virtual network.

Syntax
member-interface {ethernet node/slot/port[:subport] | port-channel number} {vlan-tag vlan-id | untagged}
Parameters
ethernet node/slot/port[:subport]
Assign the specified interface to a virtual network.
port-channel number
Assign the specified port channel to a virtual network.
untagged
Assign untagged traffic on an interface or port channel to a virtual network.
vlan-tag vlan-id
Assign tagged traffic on the specified VLAN to a virtual network.
Default
Not configured
Command mode
VIRTUAL-NETWORK
Usage information
Use this command to assign traffic on the same VLAN or interface to different virtual networks. The no version of this command removes the configured value.
Example
OS10(config)# virtual-network 10000
OS10(config-vn)# member-interface port-channel 10 vlan-tag 200
OS10(config-vn)# member-interface port-channel 20 untagged
Supported releases
10.4.2.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\