VXLAN and BGP EVPN Configuration Guide for Dell EMC SmartFabric OS10 Release 10.5.2

PDF

remote-vtep

Configures the IP address of a remote tunnel endpoint in a VXLAN network.

Syntax
remote-vtep ip-address
Parameters
ip-address — Enter the IP address of a remote virtual tunnel endpoint (VTEP).
Default
Not configured
Command mode
VIRTUAL-NETWORK VXLAN-VNI
Usage information
After you configure the remote VTEP, the VXLAN virtual network is enabled to start sending server traffic. You can configure multiple remote VTEPs. All broadcast, multicast, and unknown unicast (BUM) traffic received on an access interface is replicated on remote VTEPs. The no version of this command removes the configured value.
Example
OS10(config-vn-vxlan-vni)# remote-vtep 20.20.20.1
OS10(config-vn-vxlan-vni-remote-vtep)# exit
OS10(config-vn-vxlan-vni)# remote-vtep 30.20.20.1
Supported releases
10.4.2.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\