VXLAN and BGP EVPN Configuration Guide for Dell EMC SmartFabric OS10 Release 10.5.2

PDF

show evpn mac

Displays BGP EVPN routes for host MAC addresses.

Syntax
show evpn mac {count | mac-address nn.nn.nn.nn | evi id [mac-address nn.nn.nn.nn | count | next-hop ip-address count]}
Parameters
  • count — Displays the total number of local and remote host MAC addresses in EVPN instances.
  • mac-address nn.nn.nn.nn — Displays the BGP EVPN routes for a specific 48-bit host MAC address.

  • evi id — Displays the host MAC addresses and next hops in a specified EVPN instance, from 1 to 65535. To filter the output, display information on the host MAC address count for an EVPN ID or for a next-hop IP address, and BGP routes for a specified MAC address.

Default
Not configured
Command mode
EXEC
Usage information
Use this command to display the BGP routes for host MAC addresses in EVPN instances. The type 2 routes received from the remote VTEP is displayed only if there is a corresponding EVI configured locally.
Examples
OS10# show evpn mac
Type  -(lcl): Local (rmt): remote

EVI  Mac-Address        Type  Seq-No  Interface/Next-Hop
50   00:00:00:aa:aa:aa  rmt   0       55.1.1.3
OS10# show evpn mac count 

Total MAC Entries :
  Local MAC Address Count  :    2
  Remote MAC Address Count :    5
OS10# show evpn mac evi 811 count 

EVI 811 MAC Entries :
  Local MAC Address Count  :    1
  Remote MAC Address Count :    2
OS10# show evpn mac evi 811 next-hop 80.80.1.8 count 

EVI 811 next-hop 80.80.1.8 MAC Entries :
  Remote MAC Address Count :    2
Supported releases
10.4.2.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\