VXLAN and BGP EVPN Configuration Guide for Dell EMC SmartFabric OS10 Release 10.5.2

PDF

show mac address-table count nve

Displays the number of MAC addresses learned on a VXLAN virtual network or from a remote VXLAN tunnel endpoint.

Syntax
show mac address-table count nve {vxlan-vni vni | remote-vtep ip-address}
Parameters
vxlan-vni vni
Display MAC addresses learned on the specified VXLAN virtual network, from 1 to 16,777,215.
remote-vtep ip-address
Display MAC addresses learned from the specified remote VTEP.
Default
Not configured
Command mode
EXEC
Usage information
Use the clear mac address-table dynamic nve remote-vtep command to delete all MAC address entries learned from a remote VTEP. Use the clear mac address-table dynamic virtual-network vn-id command to delete all dynamic MAC address entries learned on a virtual-network bridge.
Example
OS10# show mac address-table count nve vxlan-vni 1001
MAC Entries for all vlans :
Dynamic Address Count :                  1
Static Address (User-defined) Count :    0
Total MAC Addresses in Use:              1

OS10# show mac address-table count nve remote-vtep 32.1.1.1
MAC Entries for all vlans :
Dynamic Address Count :                  2
Static Address (User-defined) Count :    0
Total MAC Addresses in Use:              2
Supported releases
10.4.2.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\