Displays MAC addresses learned on all VLANs and VXLANs.
Syntax
show mac address-table extended [address mac-address | interface {ethernet node/slot/port:subport | port-channel number} | static | dynamic]
Parameters
address mac-address
Display only information about the specified MAC address.
interface ethernet node/slot/port[:subport]
Display only MAC addresses learned on the specified interface.
interface port-channel number
Display only MAC addresses learned on the specified port channel.
static
Display only static MAC addresses.
dynamic
Display only dynamic MAC addresses.
Default
Not configured
Command mode
EXEC
Usage information
By default, MAC learning from a remote VTEP is enabled. Use this command to verify the MAC addresses learned both on VXLAN virtual networks and VLANs on the switch. The show mac address-table command displays the MAC addresses learned only on LAN port and VLAN interfaces.