VXLAN and BGP EVPN Configuration Guide for Dell EMC SmartFabric OS10 Release 10.5.2

PDF

show nve replicators

Displays all the replicators and their states.

Syntax
show nve replicators [vnid vnid]
Parameters
None
Default
None
Command mode
EXEC
Usage information

When you specify the VNID, the output displays details about the service nodes available for the VNID.

Example (without VNID)
OS10# show nve replicators
Codes: * - Active Replicator

BFD Status:Enabled
Replicators      State
-----------------------
2.2.2.3          Up
2.2.2.2          Up

OS10# show nve replicators
Example (with VNID)
OS10# show nve replicators vnid 10009
Codes: * - Active Replicator

BFD Status:Enabled
Replicators      State
-----------------------
2.2.2.3          Up
2.2.2.2*         Up

*— indicates service node to which the VTEP sends BUM traffic for the specific VNID.

Supported releases
10.4.3.0 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\