VXLAN and BGP EVPN Configuration Guide for Dell EMC SmartFabric OS10 Release 10.5.2

PDF

View replicators

To view the state of the replicators, use the show nve replicators command.

  • Show output with details about the replicators received from the controller.
    OS10# show nve replicators
    Codes: * - Active Replicator
    
    BFD Status:Enabled
    Replicators      State
    -----------------------
    2.2.2.3          Up
    2.2.2.2          Up
  • Show output with details about the replicators available for the VNID.
    OS10# show nve replicators vnid 10009
    Codes: * - Active Replicator
    
    BFD Status:Enabled
    Replicators      State
    -----------------------
    2.2.2.3          Up
    2.2.2.2*         Up

    *— indicates the replicator to which the VTEP sends the BUM traffic for the specific VNID.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\