VXLAN and BGP EVPN Configuration Guide for Dell EMC SmartFabric OS10 Release 10.5.2

PDF

vrf

Creates a non-default VRF instance for EVPN symmetric IRB traffic.

Syntax
vrf vrf-name
Parameters
  • vrf-name — Enter the name of a non-default tenant VRF; 32 characters maximum.
Default
Not configured
Command Mode
EVPN
Usage Information
Configure a non-default VRF for symmetric IRB for each tenant VRF. The tenant VRF is created using the ip vrf command when you enable overlay routing with IRB; see Enable overlay routing between virtual networks.
Example
OS10(config)# evpn
OS10(config-evpn)# vrf vrf-blue
Supported Releases
10.5.1 or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\