- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Dell
Battery-status light
Indicates the power and battery-charge status.
Solid white — Power adapter is connected and the battery has more than 5 percent charge.
Amber — Computer is running on battery and the battery has less than 5 percent charge.
The power and battery-status light blinks amber along with beep codes indicating failures.
For example, the power and battery-status light blinks amber two times followed by a pause, and then blinks white three times followed by a pause. This 2,3 pattern continues until the computer is turned off indicating no memory or RAM is detected.
The following table shows different power and battery-status light patterns and associated problems.
Diagnostic light codes | Problem description |
---|---|
2,1 | Processor failure |
2,2 | System board: BIOS or ROM (Read-Only Memory) failure |
2,3 | No memory or RAM (Random-Access Memory) detected |
2,4 | Memory or RAM (Random-Access Memory) failure |
2,5 | Invalid memory installed |
2,6 | System-board or chipset error |
2,7 | Display failure |
3,1 | Coin-cell battery failure |
3,2 | PCI, video card/chip failure |
3,3 | Recovery image not found |
3,4 | Recovery image found but invalid |
3,5 | Power-rail failure |
3,6 | System BIOS Flash incomplete |
Camera status light: Indicates whether the camera is in use.
Caps Lock status light: Indicates whether Caps Lock is enabled or disabled.