Dell G15 5530 Owner's Manual

PDF

Installing the keyboard-controller board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

NOTE:The keyboard-controller board is only required for computers that are shipped with a 4-zone keyboard.
Image: Installing the keyboard-controller board

Steps

  1. Using the alignment posts, place the keyboard-controller board into the slot on the palm-rest and keyboard assembly.
  2. Replace the screw (M2x2) that secures the keyboard-controller board to the palm-rest and keyboard assembly.
  3. Connect the keyboard-controller board cable to the keyboard-controller board and close the latch.
  4. Connect the keyboard-backlight cable to the keyboard-controller board and close the latch.

Next steps

  1. Install the battery.
  2. Install the base cover.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\