Dell G15 5530 Owner's Manual

PDF

Removing the display assembly

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the rear cover.

About this task

The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.

Image: Display assemblyImage: Display assembly

Steps

  1. Peel that tape that secures the display-cable latch to the system board.
  2. Open the latch and disconnect the display cable from the system board.
  3. Disconnect the dynamic-display switch (DDS) cable from the system board.
    NOTE:This step is applicable only for computers that are shipped with a 165 Hz or 240 Hz display.
  4. Remove the antenna cables from the routing guides on the right fan.
  5. Turn the computer over and place the computer on a clean and flat surface.
  6. Remove the four screws (M2.5x4) that secure the left display-assembly hinge to the palm-rest and keyboard assembly.
  7. Remove the antenna cables from the routing guides on the palm-rest and keyboard assembly, along the top side of the computer.
  8. Remove the four screws (M2.5x4) that secure the right display-assembly hinge to the palm-rest and keyboard assembly.
  9. Remove the display cable from the routing guides on the palm-rest and keyboard assembly, along the top side of the computer.
  10. Gently lift the display assembly from the palm-rest and keyboard assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\