Dell G15 5530 Owner's Manual

PDF

Removing the Ethernet and audio board

Prerequisites

About this task

The following image indicates the location of the Ethernet and audio board and provides a visual representation of the removal procedure.

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the battery.
  4. Remove the rear cover.
  5. Remove the solid-state drive.
  6. Remove the wireless card.
  7. Remove the memory module.
  8. Remove the system board.
    NOTE:The system board can be removed as an assembly with the fan and heat-sink assembly, Ethernet and audio board, and USB board attached.
Image: Removing the Ethernet and audio board

Steps

  1. Turn the system-board assembly over.
  2. Remove the two screws (M2x4) that secure the Ethernet and audio board to the system board.
  3. Disconnect and remove the Ethernet and audio board from the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\