Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell G15 5530 Owner's Manual

Installing the USB board


If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the USB board and provides a visual representation of the installation procedure.

Image: Installing the USB board


  1. Slide the USB board into the M.2 card slot on the system board and align the screw holes on the USB board to the screw holes on the system board.
  2. Replace the two screws (M2x4) that secure the USB board to the system board.
  3. Turn the system-board assembly over.

Next steps

  1. Install the system board.
  2. Install the memory module.
  3. Install the wireless card.
  4. Install the solid-state drive.
  5. Install the rear cover.
  6. Install the battery.
  7. Install the base cover.
  8. Follow the procedure in After working inside your computer.

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\