Dell iDRAC Service Module 5.0.1.0 User’s Guide

PDF

Configure iDRAC Service Module from RACADM

iDRAC Service Module (iSM) can be accessed and configured through RACADM CLI commands. To verify the status of the following features that are provided by iSM, use the racadm get idrac.servicemodule command.

  • ChipsetSATASupported
  • HostSNMPAlert
  • HostSNMPGet
  • HostSNMPOMSAAlert
  • iDRACHardReset
  • iDRACSSOLauncher
  • LCLReplication
  • #OMSAPresence
  • OSInfo
  • ServiceModuleEnable
  • #ServiceModuleState
  • #ServiceModuleVersion
  • #SoftwareRAIDSupported
  • SSEventCorrelation
  • WatchdogRecoveryAction
  • WatchdogResetTime
  • WatchdogState
  • WMIInfo

To set or configure the features, run the command racadm set idrac.servicemodule.<feature name> <enabled or disabled>.

NOTE Feature names and attributes that start with a # symbol cannot be modified.

To use iSM from RACADM, see the objects in the Service Module group in the RACADM Command Line Reference Guide for iDRAC8, iDRAC9, and CMC available at Dell.com/support.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\