Dell iDRAC Service Module 5.0.1.0 User’s Guide
Enable WS-Man remotely
With the WMI information feature, you can connect to the host Microsoft Windows WMI namespace to monitor system hardware. The WMI interface on the host is enabled by default, and you can access it remotely. However, if you want to access the WMI interfaces using WINRM’s WMI adapter, you must enable it manually as it is not enabled by default. Using this feature, you can access the WINRM WMI namespaces remotely by enabling it during installation.
This feature can be accessed using PowerShell commands. The commands that are used are as follows:
| Command | Description |
|---|---|
| Enable-iSMWSMANRemote —Status enable —Forcereconfigure yes —Createselfsigncert yes —IPAddress <IP address> —Authmode Basic, Kerberos, Certificate | Enabling and configuring the remote WS-Man feature |
| Enable-iSMWSMANRemote —Status get | Viewing the status of remote WS-Man feature |
| Enable-iSMWSMANRemote —Status disable | Disable remote WS-Man feature |
| Enable-iSMWSMANRemote —Status enable —Forcereconfigure yes —Createselfsigncert yes —IPAddress <IP address> | Reconfigure the remote WS-Man feature |
NOTE You must have a server authenticating certificate and an https protocol to work with this feature.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\