Dell iDRAC Service Module 5.3.0.0 User’s Guide
Configure iDRAC Service Module from iDRAC web interface
Log in to the iDRAC UI using the iDRAC IP address as a root or administrator user.
To use the iDRAC Service Module (iSM) from the iDRAC web interface for Dell PowerEdge 16G, 15G, and 14G servers, go to .
NOTE: Post reenabling the iSM in the iDRAC web interface under the iDRAC Service Module setup, to start iSM complete the following steps on the VMware ESXi operation system:
- On ESXi 7.0 U3, restart the SFCB service from the host system. For more information about how to disable or enable the SFCB service see, How to disable or enable the SFCB service (CIM Server) on the ESX/ESXi host.
- On ESXi 8.0 U2, start the dellism deamon service using the following command /etc/init.d/dellism start.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\