Dell iDRAC Service Module 5.3.0.0 User’s Guide

PDF

Configure the In-Band SNMP Get feature—Windows

The In-Band SNMP Get feature allows you to query the system management data over the SNMP service on the host operating system. The host SNMP services must be enabled and configured as a prerequisite for this feature.

The SNMP service on the iDRAC must be enabled. If it is not enabled, then iDRAC Service Module will enable and configure the SNMP service on the iDRAC. This feature can be enabled or disabled using any of the iDRAC interfaces or the installer.

This feature supports SNMP v1 and v2 on Microsoft Windows operating systems and SNMP v1, v2, and v3 on Linux operating systems.

NOTE:iDRAC Service Module supports only the iDRAC SNMP OID 1.3. 6.1. 4.1.674.10892.5.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\