Dell iDRAC Service Module 5.3.0.0 User’s Guide

PDF

Repair iDRAC Service Module running on Microsoft Windows operating systems

To repair the iDRAC Service Module (iSM) component that is faulty or nonfunctional, perform the following steps:
  1. Go to SYSMGMT > iSM > Windows, and then run iDRACSvcMod.msi.
    The iDRAC Service Module ˗ InstallShield Wizard screen is displayed.
  2. Click Next.
  3. Select Repair and click Next.
    The Ready to install is displayed.
  4. Click Repair to continue the process.
    You can also click Back to change your preferences.
    iDRAC Service Module component is successfully repaired.
  5. Click Finish.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\