Dell iDRAC Service Module Security Configuration Guide

PDF

Disable or remove local accounts

You can disable or remove local accounts.

  • The ismtech utility that is installed by iSM can be used to create an iDRAC user for support purposes. From the host operating system, the ismtech utility can be used to delete the user so created. As a security measure, the iSM service deletes the ismtech user account automatically after 24 hours.
  • If the administrator has created an SMUX peer password while enabling the InBandSNMPTraps feature, then this password can be cleaned up by disabling the feature using the following command: 
    /opt/dell/srvadmin/iSM/bin/Enable-iDRACSNMPTrap.sh
  • The iDRAC SNMP user who is created for the InBandSNMPGet feature can be deleted by disabling this feature using iSM installer or iDRAC interfaces.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\