Dell iDRAC Service Module Security Configuration Guide

PDF

User interfaces and the minimum privileges

The following table describes the user interface, interface access, the minimum required privilege, and subsystem of the interfaces.

Table 1. User interfaces and the required privilegesThe following table describes the user interfaces and the required privileges.
Interface Local or remote CLI or UI Privilege Subsystem
dcismcfg Local CLI Administrator Operating system
dcism-sync Local CLI Administrator Operating system
Enable-iDRACAccessHostRoute Local CLI Administrator Operating system
Enable-iDRACSNMPTrap.sh Local or remote CLI Administrator Operating system
Invoke-FullPowerCycle Local or remote CLI Administrator Operating system
Invoke-iDRACHardReset Local or remote CLI Administrator Operating system
Invoke-iDRACLauncher Local UI Administrator and non-administrator Operating system
Invoke-SupportAssistCollection Local CLI Administrator Operating system
ismspdlogs Local CLI *Dell service personnel Operating system
ismtech Local CLI *Dell service personnel Operating system
Configure WSMan Local Installer and PowerShell script Administrator Operating system
Installer Local UI, Silent Administrator Operating system
NVMe Prepare to Remove Remote UI, CLI Administrator iDRAC interfaces
TechSupportReport collection Remote UI, CLI Administrator iDRAC interfaces
Enable or disable iSM features Local or remote UI, CLI Administrator iDRAC interfaces, iSM Installer on operating system

* ismspdlogs and ismtech interface privileges are recommended for Dell Technologies service personnel as an administrator user.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\