Dell iDRAC Service Module 6.0.1.0 User’s Guide

PDF

Configure iDRAC Service Module from iDRAC web interface

Log in to the iDRAC UI using the iDRAC IP address as a root or administrator user.

To use the iDRAC Service Module (iSM) from the iDRAC web interface for Dell PowerEdge 17G servers, go to iDRAC settings > Settings > iDRAC Service Module setup.

NOTE: Post reenabling the iSM in the iDRAC web interface under the iDRAC Service Module setup, to start iSM complete the following steps on the VMware ESXi operation system:
  • On VMware ESXi 8.0 U3, start the dellism deamon service using the following command /etc/init.d/dellism start.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\