iDRAC 8/7 v2.50.50.50 User’s Guide

PDF

Configuring IP alert destinations using RACADM

To configure the trap alert settings:

To enable traps:
```
racadm set idrac.SNMP.Alert.<index>.Enable <n>
```
Parameter Description
<index> Destination index. Allowed values are 1 through 8.
<n>=0
<n>=1
Disable the trap
Enable the trap
To configure the trap destination address:
```
racadm set idrac.SNMP.Alert.<index>.DestAddr <Address>
```
Parameter Description
<index> Destination index. Allowed values are 1 through 8.
<Address> A valid IPv4, IPv6, or FQDN address
Configure the SNMP community name string:
```
racadm set idrac.ipmilan.communityname <community_name>
```
Parameter Description
<community_name> The SNMP Community Name.

To configure SNMP destination:

Set the SNMP trap destination for SNMPv3:

racadm set idrac.SNMP.Alert.<index>.DestAddr <IP address>

Set SNMPv3 users for trap destinations:

racadm set idrac.SNMP.Alert.<index>.SNMPv3Username <user_name>

Enable SNMPv3 for a user:

racadm set idrac.users.<index>.SNMPv3Enable Enabled

To test the trap, if required:
```
racadm testtrap -i <index>
```

For more information, see the iDRAC RACADM Command Line Interface Reference Guide available at dell.com/idracmanuals.