Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

iDRAC 8/7 v2.50.50.50 User’s Guide

Controller operations in non-RAID - HBA mode

If the controller is in non-RAID mode (HBA mode), then:
  • Virtual disks or hot spares are not available.
  • Security state of the controller is disabled.
  • All physical disks are in non-RAID mode.
You can perform the following operations if the controller is in non-RAID mode:
  • Blink/unblink the physical disk.
  • Configure all properties including the following:
    • Load balanced mode
    • Check consistency mode
    • Patrol read mode
    • Copyback mode
    • Controller boot mode
    • Enhanced auto import foreign configuration
    • Rebuild rate
    • Check consistency rate
    • Reconstruct rate
    • BGI rate
    • Enclosure or backplane mode
    • Patrol read unconfigured areas
  • View all properties that are applicable to a RAID controller expect for virtual disks.
  • Clear foreign configuration
NOTE: If an operation is not supported in non-RAID mode, an error message is displayed.

You cannot monitor the enclosure temperature probes, fans, and power supplies when the controller is in non-RAID mode.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\