WWN details for the Mezz cards displayed randomly in the WWN/MAC GUI page
Description
In certain configurations, if the NIC partitions are enabled, WWM/MAC page may display the MAC/WWN details for the Mezz cards that are installed in the system in random order. The display order may vary from the port or partition ordering.
Workaround
Go to the Network device page for specific device details that are associated with port and partitions.
Systems affected
PowerEdge MX series
Tracking number
194452
Unable to add iDRAC Static IP
Description
After setting iDrac static IP using IPV4 group (IPv4.1.Address, IPv4.1.Gateway,IPv4.1.Netmask) using Redfish or RACADM interface, a new IP address may not apply and system may become inaccessible.
Workaround
Use the IPV4Static group (IPv4Static.1.Address, IPv4Static.1.Gateway,IPv4Static.1.Netmask) to set static IP address.
Systems affected
All systems supported by this release.
Tracking number
185458
Partial information displayed for Mellanox Cards
Description
iDRAC interfaces only display partial information for the Mellanox network cards, such as, in InfiniBand mode the card is displayed as a NIC device. Also, no board manufacturer and version is available.
Workaround
N/A
Systems affected
All systems supported by this release.
Tracking number
179265
NIC or FC device slot listed in hardware inventory even when disabled in BIOS
Description
For some NIC or FC cards, even if the device slot is disabled in BIOS, the slot may still get listed in the hardware inventory.
Workaround
N/A
Systems affected
All systems supported by this release.
Tracking number
104535
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\