Integrated Dell Remote Access Controller 9 RACADM CLI Guide

PDF

connect

Table 1. Details of connectThe following table provides details about the connect sub command:
Description

Allows you to connect to the switch or blade serial console.

NOTE: This subcommand is only supported on the firmware interface.
Synopsis 
  • racadm connect [-b] -m <module>
Input
  • -b—binary mode.
    NOTE:If -b is used, CMC must be reset to terminate connect.
  • -m—module, and can be one of the following values:
    • server-<n>—where n = 1 to 16
    • server-<nx>—where n = 1 to 8 and x = a to d
    • switch-n—where n = 1 to 6 or <a1 | a2 | b1 | b2 | c1 | c2>
Examples
  • To connect to I/O Module 1 serial console: 
    racadm connect -m switch-1
  • To connect to server 1 serial console: 
    racadm connect -m server-1

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\