Integrated Dell Remote Access Controller 9 RACADM CLI Guide

PDF

iLKM

Table 1. Details of iLKMThe following table provides details about the iLKM subcommand:
Description The iLKM subcommand allows you to enable or disable iLKM support for a server, and rekey iLKM-supported devices on a server.

To run this subcommand, you must have the following privileges:

  • Enable—server control and configure iDRAC privileges
  • Disable—server control and configure iDRAC privileges
  • Rekey—server control and configure iDRAC privileges
  • Getstatus—login privileges
Synopsis
NOTE:To run enable or disable subcommands, the target server must have SEKM license.
To get iLKM status. 
racadm ilkm getstatus
To enable iLKM feature. 
racadm ilkm enable -keyid <keyID> -passphrase <password>
To disable iLKM feature. 
racadm ilkm disable
To request iDRAC to rekey all iLKM devices. 
racadm ilkm rekey -oldpassphrase <password> -newkeyid <keyID> -newpassphrase <password>
Input
  • -keyid—Key Identifier
  • -passphrase—Password
  • -oldpassphrase—Old Password
  • -newkeyid—New Key ID
  • -newpassphrase—New Password
Example
To get iLKM status. 
racadm ilkm getstatus
To enable iLKM feature. 
racadm ilkm enable -keyid keyID -passphrase password
To disable iLKM feature. 
racadm ilkm disable
To request iDRAC to rekey all iLKM devices. 
racadm ilkm rekey -oldpassphrase password -newkeyid keyID -newpassphrase pasword

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\