Integrated Dell Remote Access Controller 9 RACADM CLI Guide

PDF

racreset

Table 1. Details of racresetThe following table provides details about the racreset subcommand:
Description

Resets iDRAC. The reset event is logged in the iDRAC log.

To run this subcommand, you must have the Configure iDRAC permission and configure user privilege.

NOTE:After you run the racreset subcommand, iDRAC may require up to two minutes to return to a usable state.
Synopsis 
racadm racreset soft
racadm racreset hard
racadm racreset soft -f
racadm recreset hard -f
Input
  • -f — This option is used to force the reset.
Output 
racadm racreset
RAC reset operation initiated successfully. It may take up to a minute for the RAC to come online again.
Example
  • iDRAC reset
     racadm racreset

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\