Integrated Dell Remote Access Controller 9 RACADM CLI Guide

PDF

recover

Table 1. Details of Recover sub-commandThe following table provides details about the Recover subcommand :
Description

Allows you to recover the previous version of the firmware.

NOTE:To run this subcommand, you must have the Server Control privilege.
Synopsis
  • To recover the BIOS firmware:
    racadm recover <FQDD>
NOTE: BIOS.Setup.1-1 is the supported FQDD
Input
    • FQDD— Specify the FQDD of the device for which the recovery is required.
Examples
  • To recover the BIOS firmware:
    racadm recover BIOS.Setup.1-1

RAC1234: Recovery operation initiated successfully. Check the Lifecycle logs for the status of the operation by running RACADM command "racadm lclog view".

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\