Integrated Dell Remote Access Controller 9 RACADM CLI Guide

PDF

rollback

Table 1. Details of rollbackThe following table provides details about the rollback subcommand:
Description Allows you to roll back the firmware to an earlier version.
Synopsis 
racadm rollback <FQDD> [--reboot]
NOTE:To get the list of available rollback versions and FQDDs, run the racadm swinventory command.
Input
  • <FQDD>: Specify the FQDD of the device for which the rollback is required.
  • --reboot: Performs a graceful system reboot after the BIOS firmware rollback.
Example
  • To perform BIOS firmware rollback:
    racadm rollback iDRAC.Embedded.1-1
RAC1056: Rollback operation initiated successfully.
  • To perform a graceful system reboot after BIOS firmware rollback:
    racadm rollback BIOS.Setup.1-1 --reboot

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\