Integrated Dell Remote Access Controller 9 RACADM CLI Guide

sensorsettings

Table 1. sensorsettingsThe following table provides details about the sensorsettings subcommand:
Description	Allows you to perform threshold settings of the sensor. To run this subcommand, you must have Configure iDRAC privilege. NOTE:An error message is displayed when the following is performed: A set operation is performed on an unsupported FQDD. Out of range settings is entered. Invalid sensor FQDD is entered. Invalid threshold level filter is entered.
Synopsis	racadm sensorsettings set <FQDD> -level Min <value>
Input	<FQDD> — Sensor or corresponding sensor FQDD which needs a threshold configuration. Run the command, racadm getsensorinfo to view the sensor FQDD. The R/W field in the output getsensorinfo indicates if the sensor thresholds can be configured. Replace the <FQDD> field with the corresponding sensor FQDD that needs a threshold configuration. -level — threshold level for the sensor setting. Values are Max or Min.
Examples	To set the minimum noncritical threshold level for a power sensor type. racadm sensorsettings set iDRAC.Embedded.1#SystemBoardCPUUsage -level Max 95 NOTE:The entered value must be lesser or higher than the sensor critical threshold limit.