Integrated Dell Remote Access Controller 9 RACADM CLI Guide

PDF

witnessnodepoweraction

Table 1. Details of witnessnodepoweractionThe following table provides details about the witnessnodepoweraction subcommand:
Description The witnessnodepoweraction command is used to perform witness node power management operations.
Synopsis 
racadm witnessnodepoweraction <action>
Input <action> - Specifies the witness node power management operation to perform. The possible values are:
  • powerdown : power witness node off
  • powerup : power witness node on
  • hardreset : force hard witness node power reset
  • reseat : re-seat witness node
  • powerstatus : display current power status of witness node
Example
To power down witness node: 
racadm witnessnodepoweraction powerdown
To get the witness node power status: 
racadm witnessnodepoweraction powerstatus
To power on witness node: 
racadm witnessnodepoweraction powerup
To force witness node power hard reset: 
racadm witnessnodepoweraction hardreset
To re-seat witness node: 
racadm witnessnodepoweraction reseat

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\