Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Premier Sign In Dell Financial Services Partner Program Sign In
Contact Us

Your Dell.com Carts

iDRAC9 Version 6.00.15.00 Release Notes

PDF

OS deployment

Table 1. RHEL OS installation issue Unattended RHEL OS version 8.6 Installation stops at the Language selection screen.
Description Unattended RHEL OS version 8.6 Installation stops at the Language selection screen.
Workaround Manually select the language to continue the installation.
Systems Affected All systems supported by this release.
Tracking number 245112
Table 2. Unable to install Ubuntu OS Ubuntu OS deployment through Virtual Media may fail if installer checksum verification is enabled.
Description Ubuntu OS deployment through Virtual Media may fail if installer checksum verification is enabled.
Workaround Retry Ubuntu OS deployment by disabling the Installer Checksum Verification while fsck.mode is set to skip in kernel command-line option.
Systems Affected All systems supported by this release.
Tracking number 238939
Table 3. Getting an error SWC0018 during OS installation Modifying BIOS Boot Mode while installing operating system thorough Lifecycle Controller GUI, an error "SWC0018" is displayed.
Description Modifying BIOS Boot Mode while installing operating system thorough Lifecycle Controller GUI, an error "SWC0018" is displayed.
Workaround This message does not impact the installation, click OK to proceed.
Systems Affected All systems supported by this release.
Tracking number 143561
Table 4. Boot mode error during OS deployment While deploying OS using LC UI, if the current boot mode is set to UEFI and you change the boot mode to BIOS and click Finish on the last LC UI page, an error is displayed stating that the boot mode could not be set. The system reboots after you click OK. However, on next boot to LC UI, the boot mode is changed to BIOS and the boot device selected during OS deployment is discarded.
Description While deploying OS using LC UI, if the current boot mode is set to UEFI and you change the boot mode to BIOS and click Finish on the last LC UI page, an error is displayed stating that the boot mode could not be set. The system reboots after you click OK. However, on next boot to LC UI, the boot mode is changed to BIOS and the boot device selected during OS deployment is discarded.
Workaround Before deploying OS using LC UI, change the boot mode to BIOS from BIOS setup (F2 at POST).
Systems Affected All systems supported by this release.
Tracking number 98665

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\