Inspiron 13 7000 2-in-1 Service Manual

PDF

Procedure

  1. Align and place the status-light board in the slot on the palm-rest assembly.
  2. Adhere the foam securing the status-light board to the palm-rest assembly.
  3. Slide the status-light board-cable into the connector on the keyboard daughter-board and close the latch to secure the cable.
  4. Adhere the pieces of tape securing the speaker cable to the palm-rest assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\