Inspiron 13 7000 2-in-1 Service Manual

PDF

Procedure

  1. Route the display cable through the routing guides on the display panel.
  2. Slide the display cable into the connector and press down the latch to secure the cable.
  3. Slide the sensor-board cable into the connector on the sensor board and press down the latch to secure the cable.
  4. Adhere the sensor-board cable tape.
  5. Adhere the tape that secures the display cable to the display panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\