Inspiron 13 7000 2-in-1 Service Manual

PDF

Procedure

  1. Align the screw holes on the system board with the screw holes on the palm-rest assembly.
  2. Replace the screw that secures the system board to the palm-rest assembly.
  3. Align the screw holes on the system-board bracket with the screw holes on the system board and the palm-rest assembly.
  4. Replace the screws that secure the system-board bracket to the system board and the palm-rest assembly.
  5. Slide the I/O-board cable into the connector on the system board and close the latch to secure the cable.
  6. Adhere the tape that secures the I/O-board cable to the system board.
  7. Connect the power-adapter port-cable and the speaker cable to the system board.
  8. Slide the keyboard daughter-board cable into the connector on the system board and close the latch to secure the cable.
  9. Slide the display cable and the touch-screen board-cable into their respective connectors close the latches to secure the cables.
  10. Adhere the pieces of tapes that secure the display cable and touch-screen board-cable to the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\