Inspiron 14 7425 2-in-1 Service Manual

PDF

Installing the base cover

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the base cover and provide a visual representation of the installation procedure.

Image: Installing the base cover 1

Image: Installing the base cover 2

Image: Installing the base cover 3

Steps

  1. Connect the battery cable to the connector on the system board and adhere the tape that secures the battery cable to the battery.
  2. Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly, and then snap the base cover into place.
  3. Replace the four screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly.
  4. Tighten the three captive screws that secure the base cover to the palm-rest and keyboard assembly.

Next steps

  1. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\