Inspiron 14 7425 2-in-1 Service Manual

PDF

Installing the M.2 2230 solid-state drive

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

NOTE:The M.2 card installed on your computer will depend on the configuration ordered. Supported card configurations on the M.2 card slot:
  • M.2 2230 solid-state drive + 2230 mounting bracket
  • M.2 2280 solid-state drive

The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the installation procedure.

Image: Installing 2230 SSD

Steps

  1. Align the notch on the M.2 2230 solid-state to the mounting bracket.
  2. Replace the screw (M2x2) that secures the M.2 2230 solid-state drive to the mounting bracket.
  3. Flip over the M.2 2230 solid-state drive and mounting bracket.
  4. Slide and place the M.2 2230 solid-state drive and its mounting bracket on the system board.
  5. Replace the screw (M2x3) that secures the M.2 thermal plate to the palm-rest and keyboard assembly.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\