Inspiron 14 7425 2-in-1 Service Manual

PDF

Installing the palm-rest and keyboard assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the palm-rest and keyboard assembly and provides a visual representation of the installation procedure.

Image: Palm rest

Steps

Place the palm-rest and keyboard assembly on a clean and flat surface.

Next steps

  1. Install the system board.
  2. Install the display assembly.
  3. Install the power button or power button with fingerprint reader.
  4. Install the fan.
  5. Install the heat sink.
  6. Install the speakers.
  7. Install the I/O board.
  8. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive, whichever applicable.
  9. Install the wireless card.
  10. Install the memory.
  11. Install the coin-cell battery.
  12. Install the battery.
  13. Install the base cover.
  14. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\