Inspiron 14 7425 2-in-1 Service Manual

PDF

Installing the power-button

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

NOTE:This procedure is applicable only when you are installing a power-button without the optional fingerprint reader.

The following image indicates the location of the power-button and provides a visual representation of the installation procedure.

Image: Power button installation

Steps

  1. Align the screw holes on the power-button with the screw holes on the palm-rest and keyboard assembly.
  2. Replace the two screws (M2x3) that secure power-button to the palm-rest and keyboard assembly.

Next steps

  1. Install the I/O board.
  2. Install the fan.
  3. Install the base cover.
  4. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\