Inspiron 14 7425 2-in-1 Service Manual

PDF

Removing the palm-rest and keyboard assembly

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the battery.
  4. Remove the coin-cell battery.
  5. Remove the memory.
  6. Remove the wireless card.
  7. Remove the M.2 2230 solid-state drive or M.2 2280 solid-state drive, whichever applicable.
  8. Remove the I/O board.
  9. Remove the speakers.
  10. Remove the heat sink.
  11. Remove the fan.
  12. Remove the power button or power button with fingerprint reader.
  13. Remove the display assembly.
  14. Remove the system board.
    NOTE:The system board can be removed along with the heat sink.

About this task

The following image indicates the location of the palm-rest and keyboard assembly and provides a visual representation of the removal procedure.

Image: Palm rest

Steps

After performing the steps in the pre-requisites, you are left with the palm-rest and keyboard assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\