Inspiron 3505 Service Manual
Installing the base cover
Prerequisites
About this task
The following images indicate the location of the base cover and provides a visual representation of the installation procedure.
Steps
- Connect the battery cable to the connector on the system board.
- Place and snap the base cover into place on the palm-rest and keyboard assembly.
- Tighten the two captive screws (M2.5x2.5+5) that secure the base cover to the palm-rest and keyboard assembly.
- Replace the seven screws (M2.5x6) that secure the base cover to the palm-rest and keyboard assembly.
Next steps
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\